Single sided swing arm

[triplefighter]

yeah i bought the 800 arm no good so i went and bought a vfr750 95 arm straight fit expensive mistake the vfr800 swingarm is for sale if anyone wants it 2003..... comes with shock

[triplefighter]

the pivot point is way to wide i dont think machining it down would work way to wide i think it would effect the strength of swing arm

[The Phantom]

2003 VFR got a new motor design (dropped gear driven cams and went to cam chains instead), and because the swingarm pivots in the engine cases, the swingarm got a redesign too...

The newest iteration of the VFR800 released for 2014 gets a very nice looking swingarm! but again it will be the same as the 2003-2013 arm as the motor is unchanged. So potentially unusable, in Fireblades at least.

[Hagarr]

yeah i bought the 800 arm no good so i went and bought a vfr750 95 arm straight fit expensive mistake the vfr800 swingarm is for sale if anyone wants it 2003..... comes with shock

How much you chasing?

[triplefighter]

sorry the message is late $300 for swing arm and shock

[dudz]

theres a handier way of fitting the arm.
you need to take the arm down to 260mm
taking the meat off of the right side of the arm and
taking a few mm off of the right side of the frame
where the screw in spacer going in to the frame.
front sprocket will line up perfectly.
save spacing out the sprocket and milling down the hub.

Sorry to wake up this again !!.... Ive got a 98 SC33. Does this apply to the 800 sa (rather than the 750) and which years will fit please ( if you can remember ) cheers