-
Machinist wanted - Swingarm bushes/spacers
Looking for a machinist in the ACT who can make up some new swingarm pivot spacers for me. It's to adapt a 2004-05 swingarm (25mm pivot) to a 1990 frame (20mm pivot).
Thanks in advance [^]
-
Bloke with a smaller stick
if the needle bearings are going to run on them they will need to be made from hardened ang ground bearing steel
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules