Well being the clumsy dick I am, I managed to shear the head off the magnetic bolt for the speed sensor on my Acewell dash. If anyone has one stuck to a bunch of bolts in a tool box somewhere I would love to take it off your hands, (For a nominal fee of course). Thanks people.
:cool: Oblivious !!
make that two jules needs one too mate
Glenn Eason drinks and smokes and lends his arse to other blokes
I don't have a bolt, but I've got a heap of these magnets if they're any help? (that's a 20c piece btw)
Thanks Big fella, but unless they can be tapped and fitted to a rotor then they're not gonna do the job. Should just fire off a message to Ben really.
:cool: Oblivious !!
The bolt on mine is still good, I just need the nut as it cracked!!!!
i did the same, went to the local push bike store they had one there, ground it back and used adhesive to glue it on, no dramas yet....?
good luck tho
ah so im not the only dick that did that then? i just glued mine on
the one on my ride is glued on and it hasnt moved
Glenn Eason drinks and smokes and lends his arse to other blokes
hey guys, I've worked in pushbike shops for years and am sure to have some bicylce computer magnets laying about amongst bags of bits.
They are approx 8-10mm diameter by 5mm deep(varies a bit) and you can just glue it on where you need it. I'll dig some up if you need one. Just e-mail me an address and I will post them over.
i may hav one laying round from my dash, ill hav to check d garage n get bak 2 u
Thanks Scott, Ur a gent.
:cool: Oblivious !!
go to jaycar and buy some of their small rare earth magnets, and add a bit of glue
the fucker isnt going anywhere. just watch you dont get any skin caught between two of them, it hurts.
i did the same as Jay, works better than fine.
Well I glued the fukka and it seems ok. I did a test with the epoxy by sticking two bits of metal together. Took ages and 2 vice grips to pull em apart. Think it's gonna be ok. Thanks all for the advice and offers.
:cool: Oblivious !!
Posting Permissions
Reply With Quote
