thats outside the box good stuff mate i like it
Printable View
thats outside the box good stuff mate i like it
Just got tank back today..
http://i305.photobucket.com/albums/n...s/ede1beb5.jpg
IS that gloss or like a satin finish? Hard to tell in the photo.
The green is a pearl and the black is satin black.
Need to give them a polish and coat in 2 pack clear.
Does anyone know where to get rubber kits for bikes as some of mine are to far gone and would like to replace all if I can.
why would you polish then clear ,should be the other way around if that is a basecoat colour on the tank it needs to be cleared within 24hrs or rub down and do it again
Would a 2003-2004 gsxr front brake assembly suit a 94 gsxr 750.
I meant to say clear and then polish and it has been powdered coated.
Master cylinder ? or the whole lot ? calipers etc ?
The whole lot.
I thought the gixers went to a radial set up in 04, could be wrong though....
Does anyone know any links for swapping rear end of a 94 750gsxr.
so your saying you had the tank powder coated ,if so 2 pak clear might stick for a short time till it lifts off ,
the reason it wont stick is the 2 surfaces are not compatible,as powder coating is baked at time of coating ,so its already hard ,2pak clear as pav said must be painted over paint with in 24 hours
Yer thats what I thought but the powder coaster said to do that but I think I will just give it a polish.
the satin finish looks great just leave it,pm sent ,cheers
i cant pm you your mail box is full fella ,you need to empty it ,and yes i cut up my subframe to use some of it in my current subframe
I have just won a set of uni filters to fit to carbs does anyone know what size jets to fit to carb.
Is there a link anywhere to show how to.
you need to buy a stage 3 dyno jet kit
Getting nearly to installing engine stage.
Not sure if I should put wheels on first to make it easier to move or do after engine in.
http://i305.photobucket.com/albums/n...s/4bff5129.jpg
http://i305.photobucket.com/albums/n...s/88c84ddc.jpg
Would anyone have a set of front rotors to fit a 94 gsxr as mine are a bit to lose and would like black centers but can paint to suit.
I also am chasing a calipers seals kit as well.
Blue, get new ones, S3 rotors are good bang for buck mate. Its hard to find any complaints about them.
Much like these http://www.ebay.com.au/itm/330489079508