Electrical help.. fuel + temp sensor into acewell?

[sen]

Hi guys..

Need some help. Got the bike naked, got the acewell going, etc.. but my original dash had a fuel light (not a gauge), and a temperature gauge.. both of which the Acewell 2853 doesn't support.

Is there a way I can get the fuel sensor to trigger the hazard LED on the gauge.. or something.. so I know when i'm gunna run out? (VTR1000.. no reserve tank.. NEED that light!).. or make it trigger the fuel gauge so it does the "Flash when empty" thing the acewells do?

Had a local bikeshop try with some resistors etc.. with no luck..

Open to any ideas.. even seperate LEDs stuck on the triple or something.. just any way I can have my fuel light and temp light back.

[Surt]

i think u can add the option/s/ with additional led/s/ a piece of colored plex and glue sen. i had 8 led windows inmy acewell and only 4 engaged, i switched em up all, also ripped of the stock 5v leds and replaced em with 12v pin leds can add a pic if needed just would have make it :)

[Surt]

is ur fuel sensor bottom mounted sen? if so, i need 1 to ;)