FS: 1993 CR250

[pappas]

Up for sale is my 1993 CR250. It has:
New rear side gaurd and rear mudgaurd plastics New Iridium plug New Twin Air filter New wheel bearings front and back (it will have this weekend) 80% tread on front and back tyres FMF Fatty expansion chamber New FMF Powercore 2 muffler New fork oil and seals (hasn't been ridden since they've been done)

Bike is in good condition, has plenty of compression. It will need front and back discs as they are getting on the thin side. Asking $2000, I'll be putting it on egay after the weekend. Maybe sooner if no one here's keen.

http://www.asfphotos.com/upload/1258110638.jpg


http://www.asfphotos.com/upload/1258118698.jpg


http://www.asfphotos.com/upload/1258084520.jpg


http://www.asfphotos.com/upload/1258140271.jpg


http://www.asfphotos.com/upload/1258099446.jpg


http://www.asfphotos.com/upload/1258106455.jpg

[el sammo]

good year of a good bike!!! CRs rock

[Weaselman]

what oversize is the bore on?

[pappas]

Not sure of oversize. I'm pulling the cylinder off this week as the crankcase gasket is leaking which is making it hard to start when cold. So i'll be able to tell you then.

[Tony OW31]

quote:Originally posted by Weaselman

what oversize is the bore on?


You can't bore them oversize, they used nikasil coated cylinders.

[watkins]

location?

[scotty]

Cronulla, NSW

[pappas]

Not anymore mate, I'm in the Parramatta area now. I can deliver Sydney metro if required.

[Weaselman]

quote:Originally posted by Tony OW31


quote:Originally posted by Weaselman

what oversize is the bore on?


You can't bore them oversize, they used nikasil coated cylinders.



ok the piston then

[pappas]

Took the cylinder off last week, piston rings were out of spec so I've put new rings and base gasket in it. Also noticed it has a hot rods crank in it. Piston is a Wiseco standard size (66.4mm).

[Weaselman]

thanks heaps mate