LED indicators

[wackyrider]

Got a small set of LED indicators fot the front of the bike, and as usual, they are flashing fast. I tried instlling a set of resistors I had gotten with another set of LED's, but still the smae prob. However when I connected the 2 resistors in line for 1 indicator, there was enough resistance and the indicator flashed normally.

Question is, can I find stronger resistors (don't want to have to wire 2 inline for each indicator) or is it easier to just find the flasher can and replace that.

Cheers

[timbo]

I just used one large resistor for mine with no problems

[wackyrider]

Where did u buy it from? These indicators didn't come with any resistors, and the ones I have are not strong enough

[Cruisecontrol]

Dick Smith is the go.

They only cost a few cents each so grab a fist full of different ones and just work your way through them till you get the desired result.

[Iceman]

get one of these

http://www.ledshoponline.com/electronic_flasher_cans.htm

[80s freak]

Electronic flasher can from Autobarns or super cheap, about 15 bucks. No resistors needed. plug n play.

[wackyrider]

cheers boys