GSXR headlight on SV

[dirtydannyd]

Hey, I have a K3 SV1000 and was wanting to put a GSXR headlight on it. Was thinking of something like a late model GSXR 600 (upside down triangle) headlight. Don't really know where to start though...

Anyone done this?
Any tips?

Cheers.

Dan

[TurboKat]

http://www.streetfighters.com.au/forum/upload/2878159567830.jpg

[TurboKat]

http://www.streetfighters.com.au/forum/upload/2878159564305.jpg

[RED ZX]

ooh lovely bike, do you have a link to a build thread or even just a pic from the rear, loving that underseat exhaust.

[dirtydannyd]

Yeah man, that's what I'm after.
Do you have a write up on on the headlight?
Any tips?

Cheers

Dan

[_M_]

Buy one GSXR headlight , buy fibreglass, resin etc. buy moulding clay, put moulding clay on headlight till it resembles what you want, now put al-foil over where your going to glass, lay a couple of layers of glass 2-3, let set, then take off and remove the clay + foil, the glass should be fairly set, now we make the tabs on the inside to screw in the headlight and to the headlight mounts this depends on what mounts your using and what mounts are available on the light, just get short sheet glass and make some mounts for what you need, now add another layer inside your headlight to hold your tabs on better, sand your outer layer and paint.

Well thats what i would do :P

[Ten_c69]

Thank looks so good on the SV, nice find

[Weaselman]

thats pretty spiffy