Docktor
29-11-2008, 08:31 PM
Ok, I stripped my slave cylinder down because i could. Wot i didnt figure on was my goldfish memory. Which way does the rubber o ring seal go on the slave piston ?. I looked in the book and it dont show it proper. Is the flappy bit pointing towards the piston or away from it?........................
Oki, I guessed and put it in facing back towards the clutch cover, not towards the engine... My next drama. I syringe bled it up and got a "lever feel", cracked the bleed nipple and lost all feel. pulled the master off and its happy to pump air thru the banjo bolt hole but no fluid. It will even pressurise air but no fluid comes out....... ummmm why how ??
Thanks blokes.
Oki, I guessed and put it in facing back towards the clutch cover, not towards the engine... My next drama. I syringe bled it up and got a "lever feel", cracked the bleed nipple and lost all feel. pulled the master off and its happy to pump air thru the banjo bolt hole but no fluid. It will even pressurise air but no fluid comes out....... ummmm why how ??
Thanks blokes.