de-restrictors

[throttlejockey]

hi peeps,

a mate of mine with a KTM supaduke (SupaPuke as we call it) has very, very easily removed the restritors for 1st, 2nd & 3rd gear.
it was simply pulling out the (wire) sensors & leaving neutral.

so, my question is:
i know most manufacturers do it.

how do i do it to my K4 gsxr 1thou??

i might even put it back to normal gearing if i can do this.

[Tony Nitrous]

You might be looking for a TRE
(Timing Retard Eliminator)

About $100 as a "plug-in"
About 5c from Dick Smiths if you buy the right resister.

Busa is 6.8ohm and fools the ignition in 1st / 2nd / 6th (removes the 295 limiter) into thinking the bike is ALWAYS in 5th.
Been told about cold start probs but mine is fine.

I posted the "5c DIY mod" link a while back but im sure someone
on here could help you.

Tony.J.

[03gixxerpilot]

did my 03 gixxer 1000, cost about 5 bucks as a switchable setup and have never had any probs, cant remember what ohms resistor we used but same thing as the busa, fools the bike into thinking its in fith

[Booster]

Just pulling the wire probably will give a neutral or clutch in map , my busa had a cut wire when i first brought it , rev limiter cut in ~1000 rpms early and probably had a "safe" fuel and timing mapping . felt faster when the resistor was added.

[Tony Nitrous]

This is for an Eye-Abuser,
Maybe different wires/resister but others use
the same basic idea,

http://www.wardsweb.org/busa/hayabusa_mods_tre.html

Tony.J.

[03gixxerpilot]

im with booster

[03gixxerpilot]

the gixxer uses a diffrent resistor, i can't remember what the dittrence is but i do know that they are diffrent

[Tony Nitrous]

http://www.81x.com/bugman/gixxermods

and "click" RESISTERS / TRE on the left hand list.