Hey Oz

[Large]

http://www.streetfighters.com.au/forum/upload/77683529635773.jpg


http://www.streetfighters.com.au/forum/upload/77683529644330.jpg

[Large]

http://www.streetfighters.com.au/forum/upload/77683529677472.jpg

[ozkat]

Thanks mate, any idea of the offset of the top bolt on the engine mounts under the engine? How far back from the rear bolt and how far above? :D

[Large]

no :)

[ozkat]

Im sure you can easily find out by measuring them ;) Did i tell you how good you looked on your GSXR at the fools run? :D

[Large]

on the right side(bottom pic) The lower bolts are about 49mm apart and the upper bolt is ~17mm back and ~32mm up.

[ozkat]

Thanks for that mate, and the front mount is?

[Large]

so if your frame bolts aren't 49mm apart all my other measurements are prolly out too

[Large]

quote:Originally posted by ozkat

Thanks for that mate, and the front mount is?


Ally I think

[ozkat]

quote:Originally posted by Large


quote:Originally posted by ozkat

Thanks for that mate, and the front mount is?


Ally I think
No i meant the bolt spacing.

[Large]

Yeah I know.

Cant get in to measure it because of the oil hoses and headers and the bolts are on opposite sides.

Does your frame have a lower rear mount?

I'd suggest making up the lowers, then blocking the motor to suit your pipes and make up the other mounts from there

[ozkat]

ok no worries thanks mate. where the sump joins the cases, is it parallel with the frame rails that run under the motor?

[Large]

no

[Large]

the back is about 5-7 mm lower than the front

[ozkat]

Thanks mate i can get it sorted from there.