Acewell ACE - 2803 AP query

[TheBogyman]

bought one of these units off fleebay, but cant get the fucker too switch between kph and mph, as the bike is up for mot on thursday next week, i really need to figure this out, any of you guys help me out on this one, cheers,,,

[Hillsy]

Hey Bogeyman, I just downloaded this from http://www.acewell-meter.com/

You need to follow all of these steps to get to step 10 and onwards (setting the wheel circumference, MPH/KPH).

1. Setup operations include 12/24hour clock, shift RPM warning, numbers of engine rotations per signal, wheel circumference and units.
These must be set up step by step. The computer will automatic reversion to main screen if no button operation for 75 seconds at any
setting screen.
2. Press both MODE & RESET buttons to go into setting screen. In setting screens, press RESET button to add the flashing digit by 1,
press MODE button to confirm the digital setting and jump to next digit or next setting screen to be set. Press MODE button for 2
seconds at any setting screen to finish the setting and go to main screen.
3. It displays "12 or 24H and XX:XX-XX" symbols and AM/PM in case you select 12H.
4. Press RESET button converts 12/24H, press MODE button to complete the setting and jump to clock digit setting.
5. Press RESET button to increase flashing digit by one; press MODE button to confirm digit setting and jump to next digit.
6. Press MODE button to go to shift warning RPM setting screen after set clock.
7. It displays "rXXX00 RPM". Press RESET button to increase flashing digit by one; press MODE key to confirm digit setting and jump
to next digit.
8. Press MODE button to go to numbers of engine rotations per signal setting screen after completed shift warning RPM setting.
9. It displays "SPC-X.X RPM", the default value is 1.0; there are 4 options: 1.0, 2.0, 3.0 and 0.5. It means the numbers of engine rotation
per signal. For example the value 2.0 means the engine rotate 2 turns to output a signal.
10. Press RESET button to move in loop sequence from one to another value of the 4 values. Press MODE button to confirm the setting
and go to wheel circumference setting screen.
11. In "cXXXX" display, "c" means "Circumference", following 4 default digits; flashing digit is digit to be set.
12. Press RESET button to increase flashing digit by one; press MODE button to confirm digit setting and jump to next digit.
13. Press MODE button to jump to unit setting screen.
14. It displays KM/h or M/h, each press of RESET button converts unit; press MODE button for 2 seconds to confirm unit setting and
jump to main screen.

[TheBogyman]

cheers hillsy, ill have a bas at it today