PC3 USB Question

[StuNVA]

I just installed a quickshifter and the PowerCommander website say's to simply enable it in the Command Centre software but the CCsoftware for the PC3USB doesn't have the tab in the drop down menu ? It's all supposed to be compatable, am I missing something simple ?

Anyone got any suggestions while I'm waiting to hear back from DynoJet

[Hagarr]

Sorry I've gone Haltech, PC3 got too hard!

[Yella]

Have you installed the disc for the quick shifter, I will plug mine in in the morning and have a look

[StuNVA]

I had to start the bike, turn off the PC3 software, run the Quickshifter software and then close it, then open the PC3 software, all while the bike was running................ now I can't get it to change if the engine is under heavy load, I'll keep working on it but it's wareing thin.

[Yella]

what break time do you have it set at?

[Tim]

you shouldnt have to do it while the bikes running just make up a diy 9 volt plug from one of these
4922

and a couple of tiny crimps from jaycar.

[StuNVA]

I think it's fucked, I dropped the rev min to 1000 and lifted the kill to 150ms, set the little red arrow to trigger as the shifter was smack on shifting and still nothing.

So I took it off the shift lever, put the bike on a stand, ran it to 3k in second and pushed the quickshifter in and it didn't cut the engine, I'm thinking it's fucked.

[Yella]

You can check the contacts with a multimeter to make sure that it is making contact