engine blow ups show us yours

[03gixxerpilot]

http://www.streetfighters.com.au/forum/upload/72123005296580.JPG


I was looking through some old files on the puter last night and found these of the motor out of my 03 gixxer stunt bike after i " airconditioned the crank "
This was done while i was doing a high chair wheelie and lucky for me and the rider behind me (also doing a wheelie) the motor didn't seize and i landed the wheelie safely, although the oil out the the motor did catch on fire and made it a little intresting.

It would be good if everone that has pic of their engine "mods" to post them up for all to see, it could be fun.

[Gix11]

Fuck Clive, That's a good effort mate!

[03gixxerpilot]

LOL no effort at all actually, just a very long wheelie and no oil to the bottom end

[Pommy Chopper]

Love your work Clive!!! ;)

[lewis]

http://www.streetfighters.com.au/forum/upload/72123082633985.jpg


my stunters engine. Had a crowd at the airport watching, doing rolling 2nd gear high chair doughnuts (on a 60t sprocket, at about 12500 rpm). Temp stoped reading at 149 degrees, then bang [8D] couldnt find the rod :(

[Phill]

never put a 'rod out of a bike block before but have put a rod out of a cummins diesel engine. blew up a turbo, filled the inlet and cylinder head with oil and couldnt shut it off. lasted about 5mins at about 3200rpm (about 1300rpm too much) before it went bang to a sudden stop.
3 rods, all pistons, two liners, turbo,head, block and crank all completely farked.
$28k later away we go.

[03gixxerpilot]

nice work so far, keep them coming.

[devo]

I seem to recall bringing up this topic a while back anyway here is mine http://streetfighters.com.au/forum/topic.asp?TOPIC_ID=3305

[03gixxerpilot]

nice work there would have been good to see it befor it was disassembled.

[devo]

http://www.streetfighters.com.au/forum/upload/930143210169184.jpg

before dissasembly :(

[03gixxerpilot]

:( not good to see
;)hot motor thought.