Seifer
13-12-2007, 03:11 PM
Hey fighters,
I had one cylinder running really lean and the others running really rich and couldn't figure out why. Carbie's are clear, all settings the same and all in reasonable condition. Now on this one cylinder running lean I noticed the black plastic top on the carbie had 3 round plastic tabs which stuck out. This stopped the slide from sliding all the way and therefore must limit the operation of the needle. Is there any reason for this or can I file them down. This is the only carb (number 4) with this issue.
I had one cylinder running really lean and the others running really rich and couldn't figure out why. Carbie's are clear, all settings the same and all in reasonable condition. Now on this one cylinder running lean I noticed the black plastic top on the carbie had 3 round plastic tabs which stuck out. This stopped the slide from sliding all the way and therefore must limit the operation of the needle. Is there any reason for this or can I file them down. This is the only carb (number 4) with this issue.