PDA

View Full Version : Sydney Exhaust shop


Chase
09-08-2012, 09:22 PM
I know this has been bantered around before, but anyone know of a good custom exhaust mob for bikes in Sydney? Preferably someone who's good but isn't a dick and doesn't charge like a bull... too much to ask?
RevHead
09-08-2012, 09:24 PM
Does Ben do exhausts if not does he have a mob he uses.just an idea.
Jockney Rebel
09-08-2012, 09:37 PM
dennis foran in gosford best in the business
Cruisecontrol
10-08-2012, 05:27 AM
Agreed Jim. Best pipes I have ever had.
kev@vcm
10-08-2012, 08:34 AM
yeah denis is good and you pay for it as well , ive heard liverpool exhausts are good and they do ceramic coatings as well
Chase
10-08-2012, 08:55 AM
Do Liverpool exhausts do bikes?
Chase
10-08-2012, 09:22 AM
dennis foran in gosford best in the business

I always hear good things about him, but it's a bit of a trek my my place.
Chase
10-08-2012, 09:27 AM
Does Ben do exhausts if not does he have a mob he uses.just an idea.
Don't think there's any doubt Ben does good work, but location and probably cost are factors.

Yeah I know I'm being a whingy bitch but I'm south side of Syd so trying to get somewhere this side of the bridge if possible.
hooligan
10-08-2012, 04:39 PM
I've used Racers choice at seven hills for a few link pipes, but not a full exhaust. Most recently to cut off the standard can, weld on a flange (hehe, flange) and then a link pipe to fit an R6 can to my KTM. He mainly does car performance exhausts (drag racing, etc) but did the link pipes without umming and ahhing.
He was $100 an hour plus bits, link pipes for my vfr 8 were $150 (an hour plus a couple of bends), the ktm took 2 hrs.
However, up front and honest about how long it would take to do.
ALBI
10-08-2012, 05:24 PM
I've used Racers choice at seven hills for a few link pipes, but not a full exhaust. Most recently to cut off the standard can, weld on a flange (hehe, flange) and then a link pipe to fit an R6 can to my KTM. He mainly does car performance exhausts (drag racing, etc) but did the link pipes without umming and ahhing.
He was $100 an hour plus bits, link pipes for my vfr 8 were $150 (an hour plus a couple of bends), the ktm took 2 hrs.
However, up front and honest about how long it would take to do.
x2 aswell does good work