PDA

View Full Version : The Definition of Acceleration



oldskool
25-07-2012, 04:26 PM
Read this through slowly and try to comprehend the amount of force produced in just under 4 seconds! There are no rockets or aeroplanes built by any government in the world that can accelerate from a standing start as fast as a Top Fuel Dragster or Funny Car!







DEFINITION OF ACCELERATION

One top fuel dragster 500 cubic inch Hemi engine makes more horsepower than the first 4 rows of stock cars at the Daytona 500.

It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA Top Fuel dragster engine to reach the rear wheels.

Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro methane per second; a fully loaded 747 consumes jet fuel at the same rate with 25% less energy being produced.

A stock Dodge Hemi V8 engine cannot produce enough power to drive the dragster's supercharger.

With 3,000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition.

Cylinders run on the verge of hydraulic lock at full throttle.

At the stoichiometric (stoichiometry: methodology and technology by which quantities of reactants and products in chemical reactions are determined) 1.7:1 air/fuel mixture of nitro methane, the flame front temperature measures 7,050 deg F.

Nitro methane burns yellow... The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapour by the searing exhaust gases.

Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.

Spark plug electrodes are totally consumed during a pass. After halfway, the engine is dieseling from compression, plus the glow of exhaust valves at 1,400 deg F. The engine can only be shut down by cutting the fuel flow.

If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half.

In order to exceed 300 mph in 4.5 seconds, dragsters must accelerate an average of over 4G's. In order to reach 200 mph (well before half-track), the launch acceleration approaches 8G's.

Dragsters reach over 300 miles per hour before you have completed reading this sentence.

Top fuel engines turn approximately 540 revolutions from light to light! Including the burnout, the engine must only survive 900 revolutions under load.

The redline is actually quite high at 9,500 rpm.

Assuming all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs an estimate $1,000.00 per second.

The current top fuel dragster elapsed time record is 4.428 seconds for the quarter mile (11/12/06, Tony Schumacher, at Pomona , CA ). The top speed record is 336.15 mph as measured over the last 66' of the run (05/25/05 Tony Schumacher, at Hebron , OH ).

Putting all of this into perspective:

You are driving the average $140,000 Lingenfelter 'twin-turbo' powered Corvette Z06.. Over a mile up the road, a top fuel dragster is staged and ready to launch down a quarter mile strip as you pass. You have the advantage of a flying start. You run the 'Vette hard up through the gears and blast across the starting line and pass the dragster at an honest 200 mph. The 'tree' goes green for both of you at that moment.

The dragster launches and starts after you. You keep your foot down hard, but you hear an incredibly brutal whine that sears your eardrums and within 3 seconds, the dragster catches and passes you. He beats you to the finish line, a quarter mile away from where you just passed him.

Think about it, from a standing start, the dragster had spotted you 200 mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1,320 foot long race course.

...... and that my friend, is ACCELERATION!

MattyDucati
25-07-2012, 04:33 PM
Yes it is!

Large
25-07-2012, 04:46 PM
No mention of Chebbies or Frods

ALBI
25-07-2012, 06:31 PM
mate ,no its not!!!

imagine this


you come home from a night on the piss
the wife is home waiting

you fummble ur way in waking the whole house up including ur 2 yr old son that is sick and only just got to sleep moements before!

she asks you ,so wat time do you call this???

ummmm 3 am ??
now before you can even justify the word SORRY!
you are hit in the head with her fist!!
from the moement it hits ur forhead to the time ur head bounced of the door jam ,"the top fuller has only left the line and hit the second stageing beam not even at full pull yet?? but yet ur are knocked out cold in a heap!!!

and that my friend is acceleration!!!

RevHead
25-07-2012, 07:01 PM
^^^^^^^^^^ ahahahahahhahhaha^^^^^^^^^^^^^^^

oldskool
25-07-2012, 11:41 PM
Glad you enjoyed the read.

Jed
26-07-2012, 08:49 AM
I have had the pleasure of working with these guys. Got to stand about 3 metres behind it when it launched. Scared the shit out of me. Nothing compares to that experience.

Good read oldskool.

http://img163.imageshack.us/img163/7412/img3245z.jpg

http://img214.imageshack.us/img214/7247/img1255x.jpg

http://img717.imageshack.us/img717/4728/img1264hq.jpg

http://img714.imageshack.us/img714/9967/img1253n.jpg

http://img841.imageshack.us/img841/579/img1248w.jpg

bones
26-07-2012, 05:19 PM
I went over to Stan Sainty's shop one day--- It was conrod day-- He and a couple of guys were making 200 rods,
enough for a season
Bones

ALBI
26-07-2012, 07:11 PM
yeh i love the alloy rods ,ive got me one of the rods from the jack daniels doorslammer such a nice bit o kit!!

BANDITROD
26-07-2012, 08:05 PM
did that cost you a pound of coke lol

ALBI
27-07-2012, 08:36 AM
lol ,nah brettt was at eastern creek and they pulled down the doorslammer donk between runs ,i was watching and was having a yarn with him he showed me his ROD ! and that they only use once ,and he GAVE it to me lol,and its hanging up in my garage nice machine work to!!
the way i see it mate if he was doing it ,hed be in jail and found guilty!!