Going to make a start,,,or shouild i??

[TheBogyman]

http://www.streetfighters.com.au/forum/upload/7596953746005.jpg

Just bought this blade to streetfighter, so if outlaw reads this, i wanted to ask him about engine paint, where do the guys get the right colour of engine paint, and is it heat resistant paint, i have tried google for supliers, but its all drew a blank, can you ofer any advise on this subject, my plan is to finish the bandit i have hacked too bits in the garage, then in the meantime gather up most of the blade bits an pieces, like vfr rear end, paint, bellypan, exhasut, and have it ready to go, also outlaw, some links to airbrushing guys in europe who you would recommend for a first class paint job, lastly any opinions on yokes, really have my mind set of billet thug yokes, so anyone recommend a uk/europe maker for those,,,bye for now fellas, ill post a bandit pic when i get the frame back, and the engine back in her,

[zx12argh]

Regular 2K paint should do it - check out venom http://www.streetfighters.com.au/forum/topic.asp?TOPIC_ID=4510&whichpage=5&SearchTerms=venom as for the rest - good luck mate

[Gix11]

Torsten (Outlaw6660) also does a lot of billet parts mate. He might be able to answer most of your questions. I'll get him to check this topic for you.

[outlaw6660]

Hi mate!
as zx12argh wrote 2 k paint is working very well..
links from airbrushers an pics of my own made billet parts or
links to other ones i did inside here the next houres..
if you want direct contact me...
send me an email..
and let me know what billet parts you are looking for...

[TheBogyman]

http://www.streetfighters.com.au/forum/upload/49388806214870.jpg


cheers outlaw, because i am new to the boards, i cant email you until my posts go up, lookde at bens build, it turned out really well,,,ill check out the 2k paint, is there anywhere online where i can lok at some colours etc, what seat did ben op for, and did he make the seat pad or modify one from another stock bike, thanks again,,,davy as for the yokes,,,i wanted them machined and ready too fit, i am using the sock usd forks off the 929 blade, so i am hoping someone out there will have a cnc program for a set simlar to those above using the stock pin, if you can help there i would be greatfull,,

[Matt]

Go to your local paint shop and get a colour chart, or pic any colour you see and get the paint shop to match it.

[Gix11]

As for the seat mate, just look here: http://www.streetfighters.com.au/ASF_HT_seat.asp

[outlaw6660]

@the bogyman
you got a mail...

[TheBogyman]

Thanks for the seat moulding link, well clever, cheers outlaw, got the mail, took a minute before i got the pictures, i sent you a reply, any ideas on the matt paint finish i talked about, its a problem trying too get it fuel resistant, so any help on this one greatly recieved,,,i am lifting the bandit frame for my birds bike today, so ill start a thread so you can see the build, its going to be nothing like bens, but its a first before i get ripped into the blade, thanks for the help so far guys,,,