K6Thou
13-04-2012, 10:09 PM
Righto lads,
I have a garrett T25 with a .64 (I think) ex housing would it be worth my time building an exhaust manifold and the rest of the plumbing and fitting this turbo to either of my gixers ('95w or '92 oiler).
I have limited access to a mill and a lathe, I also have the start of a plenum that will accept injectors.........
Just found these specs for the turbo I have.
Compressor: T-25, 60 trim 56mm 0.60 A/R BCI-1 compressor.
Turbine: T-25, 62 trim 53.8mm 0.64 A/R turbine housing.
Any advice appreciated.
Thanks,
Dan.
I have a garrett T25 with a .64 (I think) ex housing would it be worth my time building an exhaust manifold and the rest of the plumbing and fitting this turbo to either of my gixers ('95w or '92 oiler).
I have limited access to a mill and a lathe, I also have the start of a plenum that will accept injectors.........
Just found these specs for the turbo I have.
Compressor: T-25, 60 trim 56mm 0.60 A/R BCI-1 compressor.
Turbine: T-25, 62 trim 53.8mm 0.64 A/R turbine housing.
Any advice appreciated.
Thanks,
Dan.