Wanted - Tailpiece - Bris - ZX9R, ZX6R, K3-K6 GSXR

[slip]

Need to put a new tail on the bike. Looking for a complete unit. Don't know for sure what I'm after yet, but the options listed I do like. Race glass is ok too. Will want to compare current tail measurements/angle with new piece to try and get some similarity. Seat would probably be handy too.

Let me know what you've got.

slip.

[TurboKat]

I have a Gixer thou K2 (I think) raceglass tail, $100 + postage
http://www.streetfighters.com.au/forum/upload/106685218380231.JPG

[slip]

Interested TK. Could I get a couple of measurements from you? Everytime I write/read TK I think of Tony Kirby from ADB.

1. Width of front section where the bolt holes are.
2. Total length tip - tip.
3. Width between rear bolt holes.

What's it look like from behind/underneat? PIcs would be good.
What brand is it? Hotbodies, sharkskinz etc?

Thanks.

[TurboKat]

1/ 220mm
2/ 850mm
3/ 300mm these holes aren't factory mounting points so they can be filled & you can put holes wherever you want.
No idea of the brand, it won't be Sharkskinz or Hotbodies because neither are readily available in Australia, most likely Raceglass or Racers Edge.
http://www.streetfighters.com.au/forum/upload/106685242082619.JPG

If you need to see how it looks on a bike, I recommend you go to your local used bike dealer & check out a Kwhatever model GSXR or consult the internet.

[TurboKat]

Yep, just checked - it's a K1/K2 model.

[slip]

Thanks TK, after a shot from below because I just wanted to see how much material there was underneath. I do know what they look like on a bike but every shot I find of a raceglass tail is side on - never get a look at the underside. I'll measure the beast up tomorrow.

[TurboKat]

Underneath
http://www.streetfighters.com.au/forum/upload/106685271576657.JPG

[slip]

Did you have that mounted with an undertail to a road bike or just a racebike?

[TurboKat]

Racebike

[slip]

Hmmm underside is killing it for me... Will keep it in mind though, thanks TK.