bearings which way?

just gona fit new wheel bearings in the kwak noticed in manual while checking what went where , the words FIT BEARING WITH MARKS FACEING OUTWARDS... THERE AINT NO BLOODY MARKS EACH SIDE IS THE SAME does it matter am i just worrying too much ??? any one .[?]

[Iceman]

Bearing should have numbers stamped into one side. This is the outside.

cheers iceman for imfo but I've crawled all over them with a spy glass [so i dont miss nowt]and the numbers are the same both sides .

[Deano]

wheel bearings can go in either way they are not directional.

as ice said you can fit them with the number to the outside as if you need to replace them in the future you will not have to remove the bearings to read the numbers.

TA DEANO I THOUGHT IT STRANGE THAT THEY SAID TO PUT MARKED SIDE OUTWARDS COZ IVE NETHER BOTHERED B4 ,GUESS I WAS LOOKING TOOOOOOO DEEP. the end.:(