my home made laser aligner

[chopiesel]

got a laser, level and some m4 x 75mm stainless socket heads from work and knocked this up for 60 bucks total,

should work a treat for making the right spacers for the jmc swinger

im going to take the tire off so it is square on the rim then measure it each side against the front rim, should work good on the sprockets too.

http://i53.photobucket.com/albums/g50/chopiesel/IMAG0095.jpg
http://i53.photobucket.com/albums/g50/chopiesel/IMAG0096.jpg
http://i53.photobucket.com/albums/g50/chopiesel/IMAG0097.jpg

[Surt]

awesome mate! now u can knock planes down just dont cut the engine in halves with the flamin bugger!

[rod185651]

That's cool mate, I was thinking of making one a little smaller to put on the rear sprocket and point the laser towards the front sprocket to ensure everything lines up on my rear wheel and the chain runs true....... Does that make sense?

[BANDITROD]

Yep and you can buy them for that rod

[BANDITROD]

Prob cheaper ones about but I found this first
http://www.ebay.com.au/itm/Profi-CAT-Laser-Chain-Alignment-Tool-motorcycles-/300567578969#ht_1994wt_812

[rod185651]

Ah very cool! Thanks Rod, that's now on my wish list.

Sorry Chop for highjacking your thread

[BANDITROD]

My pleasure mate

[JackTar]

Shutup cunts.

[BANDITROD]

Lol your such a fag