'04 Gixxer wiring LED flashers

[Hagarr]

i've just wired up some LED's to an '04 wiring harness and they seem to flash a bit fast, as this harness is installed to a different bike I have no idea if the originals were LED or conventional.

If I have installed incorrectly and the '04 didn't have LED can somebody sketch me a diagram of how to wire and show what size diodes I need to fit.

Thanks.

[Deano]

The originals would be STD globes maybe LEDs on the dash. If there is a 3 pin flasher can just change it for a led one

[Swordsy]

Put an electronic flasher relay in the bike. If you get one that plugs into the std relay slot, it's a simple swap over

[Yella]

You need to fit resistors
http://www.matstrad.com/images/Resistor_wiring_diagram.png
Just pick up an LED flasher can
http://www.ebay.com.au/itm/12V-LED-FLASHER-CAN-SUITS-2-3-PIN-STYLE-REPLACEMENT-/120725939309?pt=AU_Car_Parts_Accessories&hash=item1c1bd3a46d

Or from ya local bike shop

[Hagarr]

Excellent thanks guys, what I suspected, oh well back to the soldering!

When I went digging I found the parts bag the tail light came with and voila! two resistors.

Probably stupid question but I have the fork tube LED's from Exben for the front indicators, if you require resistors for the rear (tail light) do I need to fit to the front as well?

[Hagarr]

Haven't seen a flash can Deano or Yella so looks like resistors.

[Redmohawk]

resistors for left and right wont matter about front and rear to much as there on the same circuit, if its still a bit fast after doing each side you can add more.

[Hagarr]

Thanks!