Gear shift linkage rod needed

[sharky]

As it says...need 190-200mm of shaft plus the threads (left and right 6mm)
Or a shaft, same length, with the internal threads in the ends...
I have some 6mm left and right hand st/st threaded bar that's no prob.

Failing that you might have one on your bike that's the right length.. whats the bike ?
Cheers ;)

[oldskool]

Ill have a poke round Rus and let ya know.

[robmac]

Got a brand new one off a CBR600RR thats 180mm long if thats any use to you?

[sharky]

Cheers Dylan...
Robmac...is that 180mm overall or plus threads ? And if so, how much thread length ?

[robmac]

180mm overall with internal threading..

[Gitzy]

Pretty sure I got a brand new one with internal left and right 6mm threads that came with my rearsets over 180mm I didnt use.. I'll check when I get home at 1 and if it is, I'll post it off to you today Russ.

[Gitzy]

No luck mate, it seems its 225mm, spose you could trim it and retap it if you were keen, if you still want it pm me your addy and I'll have it off to you asap..

http://www.asfphotos.com/upload/1287681935.jpg

[sharky]

Cheers for the offers fellas...
Gitzy...Cheers mate, you're the winner....I can trim that one to make it spot on..
pm sent

[Gitzy]

Ahh coolies, I'm not just a pretty face...


Some would say not even :D..

[Fish]

Might have on for you Russ, I'll have a look at mesurements when i get home.

[sharky]

Big thanks to Gitzy for the tea towel...turned up today mate...
.....with a gear rod wrapped inside it..
:)

[Gitzy]

No wuccas Russ, twas me favourite tea towel too :( and shall be missed.. ;)

[sharky]

quote:twas me favourite tea towel too
I can see that...judging by the stains....;)

[sharky]

quote:twas me favourite tea towel too
I can see that...judging by the stains....;)