Watto
20-02-2007, 05:26 PM
G'day fellas
in the process of throwing a k4 gixxer 1000 radial front end onto the triple and going to change the stock springs before fitting - wondering if there's anything to look out for when doing springs in USD forks compared to the conventionals
If anyone has a pic of the breakdown of the gixxer fork assembly (as to how it all fits together) would be greatly appreciated
Second question is I need to chop the lock stop mounts of the lower triple due to wrong posi for the trumpy frame - was going to lop off with a hacksaw and then grind flat with a flap disc but not sure if that is the way to go in relation to possibly leaving gouge marks that take forever to sand out on the lower triple - was going to powdercoat it once it was modded anways
appreciate any hints
in the process of throwing a k4 gixxer 1000 radial front end onto the triple and going to change the stock springs before fitting - wondering if there's anything to look out for when doing springs in USD forks compared to the conventionals
If anyone has a pic of the breakdown of the gixxer fork assembly (as to how it all fits together) would be greatly appreciated
Second question is I need to chop the lock stop mounts of the lower triple due to wrong posi for the trumpy frame - was going to lop off with a hacksaw and then grind flat with a flap disc but not sure if that is the way to go in relation to possibly leaving gouge marks that take forever to sand out on the lower triple - was going to powdercoat it once it was modded anways
appreciate any hints