Been stuffing about in the shed a little on many projects , this one will prob give most here a laugh.
Take some junk
Add some more junk
Mod some of junk just a little
Mod and add some other non bike junk
Fire up the portable sun tan machine and add bits together
Make a little pretty
And wow holds air ! No explosion at 80 psi bead seating pressure. Take a front end widen and use as a swing arm.
A bit much for an offset sprocket ? Will run a counter shaft off swing arm pivot to keep chain tension happy.
Cant have such a wide rear and no balance up front now can we
Needs brakes but
and other do dads
Need a front end to hold it
Waste of time all this fluffing without some motivation eh, take one dead $10 chink 125cc
Dead cause the chain came off through lack of maintenance I'd guess , this took out ignition trigger so no spark.
Ewww hard to weld chink cast turd ali , far from my best work But motor runs.
Cut, grind, and drill now 125 motor lives where a 90 should.
Hmmmm a muddy for the back might be nice, got cheap tape !
A little Pva and some wax
Fibber grass
And tart it up with a strip of 3/4 fubar carbon
Nope not like this but close enough
Starting to take shape
Haven't touched it in over a month and this is about as far as its gone. Doesn't need to be done till around Feb been busy with work n shit more to come.