runner bungs r made from stainless
been choosing rear sets, those i like the best, neither too primitive nor too complex, i looked through hundreds on ebay, from cb400's to busa's
quite symbolic that those r from zxr1000 so i bought the rear brake master cylinder from the big ninja as well
the quality is perfect and just $138!
gunna replace adapter plates for mine own though
I so want to see how this turns out. Keep it coming mate.
Surt ..can only say Fuckin Amazing i just love that fuel tank
what this man said
thanks heaps mates, i like, too, how it's turned out with the old russian Kovrovets tank and old kaza (sounds same with a 'she-goat' in russian lol)'s frame, never done it before, i mean bracing and knee cut-outs in a steel tank. must say that a steel sheet is easier stuff for shaping than ally just because its thinner
undertray/seat/toolbox combo (lol) mounts
decided to cut off the rear section for a few reasons and behold it is very good
ust mounts welded
rear sets adapters mockup, just a mock up
feels comfortable
zorst flanges from stainless
a runner mock up, noticed it runs too close to the frame tubes, taken into concideration
Mate your builds are a great read. Keep up the good work
Cheers Matt
I hate being bipolar, its awesome!
what are you using for the runner mock up?
Looks like foam pipe lagging and gladwrap?
Unreal! You bent those angles spot on.
as usual mate great work .
what type of welder you using ?
yup especially given the fact that i bend them with an old electric tube bender, very powerful but with just 2 buttons 'forwad' and 'backward' and huge inertia. so i usually bend them less than i need and then put a long tube on the pipe i bend, and then bent it manually to the needed angle (still on the tube bender)
a chinese tig welder mate