I would be too...
Wow, looking good Mark
Painted and finished off the side plates and linkages.
Attachment 4846 Attachment 4847
Then started on the electrics, fitted the battery box etc.
Rewrapped most of the main harness and zip tied it in only to discover the tail light and dash lights wont come on, FUCK!! after a fair bit of electrical circuit study and head scratching I did some exploratory surgery on the harness and found the break, Thank fuck for that, electrics aren't one of my strong points.
Re soldered the break and put it all back again, all good.
Got the new tyres on the rims.
But not there yet, thinking of putting a Buel 1125CR mudguard on or making my own, give me your opinions please.
That front guard looks good mate, you should try that.
Shorty chromed steel guard, it'd fit the 'original but custom' feel of the rest of the bike I reckon.
looking good mate
I'd wait till you got the bars on , will prob change the percevied hight. But I think they might look nicer a little lower just the same
Getting close now, Still waiting for the flat bars, bar ends, hand grips, switch gear, grab rail, rear blinkers, clutch cable and a few other bits which should arrive next week.
I decided to go with the Buell guard, I also dropped the headlight about Two inches, I think it looks ok.
The chain was a squeeze, about two mill each side.
Getting close mate. I'll have to get over there soon hey?
Yeh, I think its about time for another Barby then ride. You got your balance back yet Si?
mark she is lookin spick
I'm liking the front guard mark
this bike is awesome , my dream build , top work
You dun good Mark.
Man I'm looking forward to seeing this!