Printable View
I wanna shorten them. They piss me off.
Can pay in beer or small amount of cash if required.. I have no garage, welder, and even if I did I have no skills [:p]
I want to have them finish just behind the rear pegs, so just cut'n'shut a few inches off:
http://imgur.com/vM7bfh.jpg
Depending on whether they're a straight-through (absorption) baffle or a mechanical reverse-flow muffler as to how hard this job will be.
Better off selling them and re-investing in cheaper mufflers.
Ah I thought I could just chop the ends off at the edge, chop 6inchs out, and re-weld the ends back on :P
Didn't realise it was more than that. Never looked inside a muffler!
mattys shorty pipes are good dont know if there the look ya after or not.
I dun be liking shorty pipes...but that's just me
They're not my first choice, but funds are tight, so figured chopping these down is better than what they look like now.Quote:
quote:Originally posted by bladehunter
I dun be liking shorty pipes...but that's just me
Ultimately i'd like go 2-into-1 dumping underneath, but that requires money.
Got a link mate?Quote:
quote:Originally posted by thepj
mattys shorty pipes are good dont know if there the look ya after or not.
Nevermind, found them. Awesome looking, but bit expensive for me considering i'd need 2 of them and then make up mid-pipes and stuff.. will keep it bookmarked for later though.