HOW TO

Blogs on how to do things from the guys that know how!

  1. How to "recalculate speedo readings with non-standard sporckets"

    How to "recalculate speedo readings with non-standard sporckets"

    Submitted by Exben (Ben Shaw - Extreme Creations)
    ...
    Categories
    HOW TO
  2. How to "Convert a Diaphragm clutch unit to a Coil Spring Clutch unit"

    How to "Convert a Diaphragm clutch unit to a Coil Spring Clutch unit"

    -
    Submitted by Deano (Dean Molloy)
    ...
    Categories
    HOW TO
  3. How to "Make a Shorty can"

    How to "Make a Shorty can"
    Submitted by EXBEN (Ben Shaw - Extreme Creations)

    ...
    Categories
    HOW TO
  4. Suzuki GSF 1200 Bandit to Suzuki GSXR 600/750 - K4/K5 Front End Fork Conversion.

    This front end conversion applies to all Gen 1 B12 Bandits to accept a GSXR 600/750 K4/K5 USD Radial Fork setup retaining the original B12 Front wheel , Brake rotors, steering stem and steering head bearings..

    What you will need to complete this task:

    * Generation 1 Suzuki GSF1200 1996 – 2000 Model

    NOTE: The front ends for the Suzuki GSXR 600/750 K4/K5 are all Identical this includes yokes, forks, calipers and axle are ALL IDENTICAL so this means if you ...

    Updated 31-12-2011 at 07:29 PM by Gitzy

    Categories
    HOW TO
  5. Casting a seat from a fiberglass mould

    Now I have my mould I need to prep it ready for fiberglassing. I started with 240 wet and dry then went to
    400, 600, and finished up with 1200 then T cut to get it as shiney inside as I could
    Now ten coats of wax.



    Well, the mold has had ten coats of wax, and its ready for P.V.A.



    Because the surface has been ...
    Categories
    HOW TO
Page 3 of 5 FirstFirst 12345 LastLast