Jay_G
19-12-2009, 09:26 PM
this is sitting in my garage taking up space since i bought a newer bike, and i keep thinking about fitting knobbies on it and doing the mackay beach races and belting through the bush when i should sell it and buy stuff for the baby on the way, the rear wheel is an 18 so a knobbie would go on nicely. Or using the spare short motor to turn it chain drive and put it in a go kart.
$700
located in Flinders View (Ipswich)
0412061348
07 32941171
Engine:
* Wiseco 810 big bore kit
* 30 thou off the head
* new timing chain when built
* OEM gaskets = fucking expensive
* conversion from mech advance to electronic.
* unifilter pods on the Mikuni BS34 carbs.
* altered zx750 pipes to fit
* new clutch plates not long ago.
* later model zxr750 base engine included(bottom half of case stuffed) for the chain drive components if you want to convert it to chain.
pulled 72.8 rwhp on Ipswich Kawasaki dyno was a running lean and the old dodgy mech ign advancer, i think jetted correctly and running through i chain it would get 80 to 85 rwhp
needs a bit of jet work and float adjustment to get running right i didn't get around to getting the dynojet kit i wanted.
forks need a bottom triple and bearings to go back in, i butchered the old triple for a fork conversion.
needs a back tyre if going to rego, good pads all around, braided lines ADR aproved (cost $260 to get custom made) tank has been bare metal/etched and needs the dents filled but no rust, to get it going it would need some ignition leads and a little wiring.
all the bits for it in the pictures are included
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale001.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale004.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale002.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale003.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale005.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale006.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale007.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale008.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale009.jpg
this is essentially what it looked like before the strip down and sale of some bits. Note only the parts in the pics above are included.
http://i39.photobucket.com/albums/e183/Jay_G84/IMG_0015.jpg
$700
located in Flinders View (Ipswich)
0412061348
07 32941171
Engine:
* Wiseco 810 big bore kit
* 30 thou off the head
* new timing chain when built
* OEM gaskets = fucking expensive
* conversion from mech advance to electronic.
* unifilter pods on the Mikuni BS34 carbs.
* altered zx750 pipes to fit
* new clutch plates not long ago.
* later model zxr750 base engine included(bottom half of case stuffed) for the chain drive components if you want to convert it to chain.
pulled 72.8 rwhp on Ipswich Kawasaki dyno was a running lean and the old dodgy mech ign advancer, i think jetted correctly and running through i chain it would get 80 to 85 rwhp
needs a bit of jet work and float adjustment to get running right i didn't get around to getting the dynojet kit i wanted.
forks need a bottom triple and bearings to go back in, i butchered the old triple for a fork conversion.
needs a back tyre if going to rego, good pads all around, braided lines ADR aproved (cost $260 to get custom made) tank has been bare metal/etched and needs the dents filled but no rust, to get it going it would need some ignition leads and a little wiring.
all the bits for it in the pictures are included
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale001.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale004.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale002.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale003.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale005.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale006.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale007.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale008.jpg
http://i39.photobucket.com/albums/e183/Jay_G84/gtsale009.jpg
this is essentially what it looked like before the strip down and sale of some bits. Note only the parts in the pics above are included.
http://i39.photobucket.com/albums/e183/Jay_G84/IMG_0015.jpg