PDA

View Full Version : Bare Honda RC30 Single-Sided Swingarm - SOLD


Seven6
01-03-2009, 11:33 PM
This is my number 1 prize possession parts wise, but need space.

Pics are for reference only, will post more (actual photos) tomorrow.

Was bought for a project that never happened, have matched it up to a friends VFR400R to check sizing and is a good inch longer. That said I can't confirm if it is a genuine RC30 part - was told it was from a HRC race bike though.

Has been part polished, but has some scratch/wear marks. Has no axle or rear hub parts included though has swingarm/frame bearings attached.

Asking $280 inlc. postage

http://www.streetfighters.com.au/forum/upload/20594755635581.jpg
[u]</u>

http://www.streetfighters.com.au/forum/upload/2059475566016.jpg
Seven6
02-03-2009, 06:35 AM
A few views of actual swingarm.

http://www.streetfighters.com.au/forum/upload/20594864263904.jpg


http://www.streetfighters.com.au/forum/upload/20594864255160.jpg


http://www.streetfighters.com.au/forum/upload/20594864281963.jpg


http://www.streetfighters.com.au/forum/upload/20594864283102.jpg
Seven6
03-03-2009, 01:27 PM
Apologies slight mistype [:I], price corrected - asking $280 incl. postage
Tony OW31
03-03-2009, 01:58 PM
What is the distance from the center of the pivot to the center of the wheel spindle?
Seven6
03-03-2009, 02:11 PM
will check tonight and let you know
damo1
03-03-2009, 02:18 PM
Just so you know the hub for a VFR800 is about 600$ alone.

So i'd hate to think how much a RC30 hub would cost
Seven6
03-03-2009, 03:04 PM
I'm pretty sure some parts from the VFR400 (NC30) are compatible with this.

Have also seen the hubs etc. listed on some U.S. parts sites from about US$300
Seven6
03-03-2009, 08:33 PM
Approx measurements

http://www.streetfighters.com.au/forum/upload/62380988951029.jpg
Seven6
06-03-2009, 08:01 PM
Again if you want it, make me an offer will consider anything reasonable.