Tony OW31
15-02-2009, 10:06 PM
http://www.streetfighters.com.au/forum/upload/884893167120936.JPG
Just finished a project using this stuff, and thought it might be of interest to anyone that does fibreglass/carbon fibre moldings.
It is a castable material that can then be easily shaped or machined then you can lay up on top of it. But the best thing about it is the fact it is water soluble, so there are no de-molding issues, instead of strugling to get the part off, or making multi part molds, you just hose it out.
It's called aqua-core. Might be a re-post, but I aint seen it mentioned on here before.
Just finished a project using this stuff, and thought it might be of interest to anyone that does fibreglass/carbon fibre moldings.
It is a castable material that can then be easily shaped or machined then you can lay up on top of it. But the best thing about it is the fact it is water soluble, so there are no de-molding issues, instead of strugling to get the part off, or making multi part molds, you just hose it out.
It's called aqua-core. Might be a re-post, but I aint seen it mentioned on here before.