PDA

View Full Version : Akraprovic Full system for ZX7R $450


EXBEN
06-05-2008, 08:00 PM
Stainless Full system to suit a 96- ZX7R, the can has been reskined but still looks great,the rest of the system is also in exelent condition with no dents.
These are over $2000 new
Asking $450
http://www.streetfighters.com.au/forum/upload/1034804520138128.jpg
EXBEN
06-05-2008, 08:02 PM
http://www.streetfighters.com.au/forum/upload/1034804520101104.jpg
TurboKat
06-05-2008, 10:26 PM
Can you measure the port spacings & inlet O.D's for me please Ben? Or do you know if I can adapt this to my ZX9 B?
EXBEN
07-05-2008, 09:20 AM
This ok ?

http://www.streetfighters.com.au/forum/upload/1034808964146872.jpg


http://www.streetfighters.com.au/forum/upload/1034808964104264.jpg
TurboKat
07-05-2008, 10:10 AM
You're a Champignon Ben, I'll get me measurin stick out.
TurboKat
07-05-2008, 10:09 PM
FUCK IT :( I need 330mm as an absolute bare minimum height preferably more to clear the sump on the 9. [V]
That system is exactly the design I need too :(
Bugger.
EXBEN
07-05-2008, 10:21 PM
I measured 320 from the bottom of the lip is that where you measured from.
TurboKat
08-05-2008, 12:16 AM
Yep, from the bottom of the exhaust port to the sump is 327mm +/- 1mm.
It would be a shame to have to cut it up to lengthen the pipes & make it fit. :(