PDA

View Full Version : K&N Crankcase vent filter ....Sell or swap


sharky
21-08-2006, 09:03 PM
http://www.streetfighters.com.au/forum/upload/2244631717189.jpg
This lil bugger is 75mm diameter by 58mm high plus inlet (which is 25mm internal bore)
I am after a smaller bodied filter (preferably with Blue anodized finish) and a 3/4" inlet.
Offers anyone ??????
21-08-2006, 09:31 PM
Monza make a smaller blue onodised filter with 4 different sized inlets mate,$9.95 at the big red and yellow auto shop.
Iceman
21-08-2006, 10:14 PM
Do a search on monza crank case breather and you'll find a pic of it, I think Des, (suzukifreak) posted it first.
sharky
22-08-2006, 09:07 PM
Trouble is Ice that the Supercheaps round here haven't got 'em.
I thought someone might like a pukka K&N one for a drag bike or summat ???
Oh well..off to evil bay it goes.....
Iceman
22-08-2006, 09:08 PM
I've gotta go to Shepparton on Monday, do you want me to get you one?
sharky
22-08-2006, 09:23 PM
That would be great mate. :D:D:DJust let me know what I owe ya and I will do it by bank transfer.
Iceman
22-08-2006, 09:47 PM
We'll call it an even swap for the earls fittings you sent me. You better email me your address.
sharky
23-08-2006, 07:31 PM
Did you have any luck today mate ?
Also, which was the tattooist we were talikng about at Winton ? The wife wants to get some work done.
Iceman
23-08-2006, 08:02 PM
Going Monday, not today. As it happens that's the reason I'm going over, just getting some work done on the back of my arm.

You've got mail.
suxukifreak
23-08-2006, 08:06 PM
I got mine from Supercheap but its a superstore with a bigger range.


http://www.streetfighters.com.au/forum/upload/44142615174749.jpg
Iceman
23-08-2006, 08:35 PM
The Shepparton supercheap still had some last week when I was in there, so did Autobarn.
Slingblade
27-08-2006, 10:20 AM
You guys are life savers. I have been looking for a crankcase breather filter. K&N one is $50! and they have none in stock with the 16mm inner flange diameter i need. Same with BMC. Does anyone know if the 4 different sizes includes a 16mm??
Slingblade
27-08-2006, 10:23 AM
I dont care if it is anodized or not as it will be under the tank anyway. Blades vent from the head.
Iceman
27-08-2006, 11:36 AM
From memory they were 12mm,
Iceman
27-08-2006, 11:37 AM
18mm,
Iceman
27-08-2006, 11:39 AM
20mm and 25mm.
Slingblade
27-08-2006, 12:04 PM
hahaha. Typical. I think the 12mm with a 16mm drill bit through it will do fine. 10 bucks sounds good to me. Thanks.